SLM GUI prompts for a certificate to be selected every time you try to access the site.

The portal will load if the certificate is either accepted or cancelled but it will prompt again the next time the portal is opened.

Certificate prompts appears before logging on to SLM GUI.

On the server, Open cmd prompt ->Run as an Administrator

netsh http show sslcert

This shows all certificates in use. Choose the certifacte that uses port 443 (this might vary if a different port is used during installation)

To change it after the cert was installed, use Registry editor and go to:

HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\HTTP\Parameters\SslBindingInfo\

Navigate to the Certificate entry with :443.
Click that entry and modify the DefaultFlags

Change this to 0 based on the values mentioned below:

 

0 – DS Mapper disabled and Negotiate Client Certificate is disabled.

1 – DS Mapper is enabled and Negotiate Client Certificate is disabled.

2 – DS Mapper disabled and Negotiate Client Certificate is enabled.

3 – DS Mapper and Negotiate Client Certificate are both enabled.

Restart the HTTP service using:

Net stop http

Net start http

Confirm everything is still working, without prompting to select a certificate to use to authenticate the credentials when logging in.

Please contact Snow Support  for any further assistance.